NetApp DS460C User Manual

• The following illustration shows how the drives are numbered from 0 to 11 in each drive drawer within the
shelf.
Steps
1. If you want to manually assign disk ownership for the replacement disk drive, you need to disable
automatic drive assignment if it is enabled; otherwise, go to the next step.
You need to manually assign disk ownership if disk drives in the stack are owned by both
controllers in an HA pair.
You manually assign disk ownership and then reenable automatic drive assignment later in
this procedure.
a.
Verify if automatic drive assignment is enabled:
storage disk option show
If you have an HA pair, you can enter the command at the console of either controller.
7

NetApp DS460C Specifications

General

Model	DS460C
Category	Storage
Form Factor	4U
Drive Support	60 drives
Drive Types	SAS
Connectivity	12Gb/s SAS
Host Connectivity	SAS
RAID Support	RAID 6 (with NetApp storage controllers)