Video two of two: Performing end-to-end software configuration
The following video shows end-to-end software configuration for systems running ONTAP 9.6 and later.
Detailed steps - FAS9500
This article gives detailed step-by-step instructions for installing a typical NetApp system.
Use this article if you want more detailed installation instructions.
Step 1: Prepare for installation
To install your system, you need to create an account on the NetApp Support Site, register your system, and
get license keys. You also need to inventory the appropriate number and type of cables for your system and
collect specific network information.
You need to have access to the
NetApp Hardware Universe for information about site requirements as well as
additional information on your configured system.
What you need
You might also want to have access to the
ONTAP 9 Release Notes for your version of ONTAP for more
information about this system.
You need to provide the following at your site:
• Rack space for the storage system
• Phillips #2 screwdriver
• Additional networking cables to connect your system to your network switch and laptop or console with a
Web browser
Steps
684
To Next Page
Loading...
