5.
Verify that the switchback operation has completed:
metrocluster show
The switchback operation is still running when a cluster is in the waiting-for-switchback state:
cluster_B::> metrocluster show
Cluster Configuration State Mode
-------------------- ------------------- ---------
ÊLocal: cluster_B configured switchover
Remote: cluster_A configured waiting-for-switchback
The switchback operation is complete when the clusters are in the normal state.:
cluster_B::> metrocluster show
Cluster Configuration State Mode
-------------------- ------------------- ---------
ÊLocal: cluster_B configured normal
Remote: cluster_A configured normal
If a switchback is taking a long time to finish, you can check on the status of in-progress baselines by using
the
metrocluster config-replication resync-status show command.
6. Reestablish any SnapMirror or SnapVault configurations.
Restore OKM, NSE, and NVE as needed - FAS8200
Once environment variables are checked, you must complete steps specific to systems
that have Onboard Key Manager (OKM), NetApp Storage Encryption (NSE) or NetApp
Volume Encryption (NVE) enabled.
Determine which section you should use to restore your OKM, NSE, or NVE configurations:
If NSE or NVE are enabled along with Onboard Key Manager you must restore settings you captured at the
beginning of this procedure.
• If NSE or NVE are enabled and Onboard Key Manager is enabled, go to
Option 1: Restore NVE or NSE
when Onboard Key Manager is enabled
.
• If NSE or NVE are enabled for ONATP 9.5, go to
Option 2: Restore NSE/NVE on systems running ONTAP
9.5 and earlier
.
• If NSE or NVE are enabled for ONTAP 9.6, go to
Option 3: Restore NSE/NVE on systems running ONTAP
9.6 and later
.
Option 1: Restore NVE or NSE when Onboard Key Manager is enabled
Steps
1. Connect the console cable to the target node.
2.
Use the
boot_ontap command at the LOADER prompt to boot the node.
19
To Next Page
Loading...
