FAS8300 and FAS8700 System Documentation
Install and setup
Start here: Choose your installation and setup experience
For most configurations, you can choose from different content formats.
•
Quick steps
A printable PDF of step-by-step instructions with live links to additional content.
•
Video steps
Video step-by-step instructions.
•
Detailed steps
Online step-by-step instructions with live links to additional content.
For MetroCluster configurations, see either:
• Install MetroCluster IP configuration
• Install MetroCluster Fabric-Attached configuration
Quick guide - FAS8300 and FAS8700
This guide gives graphic instructions for a typical installation of your system from racking
and cabling, through initial system bring-up. Use this guide if you are familiar with
installing NetApp systems.
Access the Installation and Setup Instructions PDF poster:
FAS8300 and FAS8700 Installation and Setup Instructions
Videos - FAS8300 and FAS8700
There are two videos; one showing how to rack and cable your system and one showing
an example of using the System Manager Guided Setup to perform initial system
configuration.
Video one of two: Hardware installation and cabling
The following video shows how to install and cable your new system.
FAS8300 and FAS8700 Installation and setup instructions
Video two of two: Performing end-to-end software configuration
The following video shows end-to-end software configuration for systems running ONTAP 9.2 and later.
1
To Next Page
Loading...
