b. Click Reboot Controller.
The appliance reboots and rejoins the grid. This process can take up to 20 minutes.
c. Monitor the status of the upgraded appliance Storage Node in the Grid Manager.
Verify that the appliance returns to the expected status.
Related tasks
Accessing SANtricity System Manager
on page 35
Related information
E2800 and E5700 SANtricity Software and Firmware Upgrade Guide
E-Series and SANtricity 11.5 Documentation Center
NetApp Downloads: Software
Replacing an E2800 controller
You might need to replace an E2800 controller if it is not functioning optimally or if it has failed.
Before you begin
• You have a replacement controller with the same part number as the controller you are replacing.
• You have labels to identify each cable that is connected to the controller.
• You have an ESD wristband, or you have taken other antistatic precautions.
• You have a #1 Phillips screwdriver.
• You have the E-Series instructions for replacing a controller in duplex configuration.
Attention: Refer to the E-Series instructions only when directed or if you need more details to
perform a specific step. Do not rely on the E-Series instructions to replace a controller in the
StorageGRID Webscale appliance, because the procedures are not the same.
About this task
You can determine if you have a failed controller in two ways:
• The Recovery Guru in SANtricity System Manager directs you to replace the controller.
• The amber Attention LED on the controller is on, indicating that the controller has a fault.
Attention: If both controllers in the shelf have their Attention LEDs on, contact technical
support for assistance.
Maintaining the SG6000 appliance |
67
To Next Page
Loading...
Need help?
General
