NetComm Wireless 4G M2M Router
List of get/set commands
The following table is a partial list of get and set commands which may be performed via SMS.
Returns the Module firmware version, LAN IP Address, Network State, Network operator and
RSSI.
Returns the time and date of recent sessions along with the total amount of data sent and
received for each session.
set
syslogserver=123.45.67.89:514
Sets a remote syslog server IP or hostname and port.
Enables or disables Connect on demand.
Returns the enable/disable status of the Connect on demand feature.
Returns the connection status of the Connect on demand feature.
Sets the Connect on demand feature to connect only when traffic is received on the specified
port.
Returns the Connect on demand port filter status and list or filtered ports.
Sets the router to stay online for at least X minutes when data activity is detected.
Returns the number of minutes the router is configured to stay online when data activity is
detected.
Sets the router to stay online for a minimum of X minutes after connecting.
Returns the minimum number of minutes the router should stay online after connecting.
Sets the number of minutes that the router should not attempt to redial after hanging up.
Returns the number of minutes that the router is configured to not attempt to redial after
hanging up.
Sets the number of minutes after which the router should disconnect regardless of traffic.
Returns the number of minutes the router is configured to disconnect regardless of traffic.
Sets the number of minutes that the router should regularly attempt to connect.
Returns the number of minutes that the router is configured to regularly attempt to connect.
Sets the number of minutes that the router should randomise the dial time by.
Returns the number of minutes that the router is configured to randomise the dial time by.
Sets verbose logging on or off.
Returns the status of verbose logging.
Sets the router to ignore ICMP packets triggering data activity detection.
Returns the status of the Ignore ICMP option.
Sets the router to ignore TCP packets triggering data activity detection.
Returns the status of the Ignore TCP option.
Sets the router to ignore UDP packets triggering data activity detection.
Returns the status of the Ignore UDP option.
Sets the router to ignore DNS traffic triggering data activity detection.
Returns the status of the Ignore DNS option.
Sets the router to ignore NTP traffic triggering data activity detection.
Returns the status of the Ignore NTP option.
Sets the router to ignore NCSI traffic triggering data activity detection.
Returns the status of the Ignore NCSI option.
Instructs the router to perform a network scan and returns the results by SMS.
Sets the operator to a manual selection made by the user where “505” is the Mobile Country
Code for Australia and “3” is the Mobile Network Code for Vodafone. As no network type (e.g..
LTE/3G/2G) is specified, it is selected automatically.
Returns the operator and network type selection mode (Automatic/Manual), in addition to the
MCC and MNC values
Returns the PPPoE status, currently configured dial string and service name
set pppoe=1, telstra.internet, test
Sets the PPPoE status on, APN to telstra.internet, and service name to test.
To Next Page
Loading...
Need help?
General
