Apply the Standard Preset Mode
The Standard Preset mode, which is the default mode, gives all ports equal prioritization and does not limit
the rate on any ports.
Applying the Standard Preset mode does the following:
• Sets the QoS port priority for all ports to High.
• Enables IGMP snooping for the switch (for more information, see Manage IGMP Snooping on page 50).
• Disables flow control for all ports (for more information, Manage Flow Control for a Port on page 39).
• Disables power saving for the switch (for more information, see Manage the Power Saving Mode on
page 63).
• Sets the QoS mode to port-based (for more information, see Use Port-Based Quality of Service and
Set Port Priorities on page 30).
Before you apply the Standard Preset mode, you can save your current QoS, port prioritization, rate limiting,
multicast, flow control, and IGMP snooping settings and other settings as a custom preset mode (see Save
Your Quality of Service Settings as a Custom Preset Mode on page 26) so that you can easily revert to your
current QoS configuration.
To apply the Standard Preset mode:
1. Open a web browser from a computer that is connected to the same network as the switch or to the
switch directly through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
The login page opens.
3. Enter the switch password.
The default password is password. The password is case-sensitive.
The Home page displays.
Optimize the Switch Performance
24
Nighthawk S8000 Gaming & Streaming Advanced 8-Port Gigabit Ethernet Switch (GS808E)
To Next Page
Loading...
General