Factory Settings
You can return the switch to its factory settings. Use the end of a paper clip or some other similar object to
press and hold the RESET button on the bottom panel of the switch for at least five seconds.The switch
resets and returns to the factory settings that are shown in the following table.
Table 2. Factory default settings
Default SettingFeature
Access point login and discovery
DHCP client. Enabled. That is, an IP address is issued to the switch by a
DHCP server in the network.
Standalone IP address. 192.168.0.239 with subnet mask 255.255.255.0
IP address
passwordLogin password
All enabled (UPnP, Bonjour, and NSDP)Switch discovery protocols
QoS
Port 1. Gaming
Port 2. Media streaming
Port 8. Uplink
QoS port assignments
Port-basedQoS mode
High (all ports)Port priority
None (for all ports)Port rate limits
DisabledFlow control
DisabledBroadcast filtering
None (for all ports)Port storm control rate limits
Multicast
EnabledIGMP snooping
DisabledBlocking of unknown multicast
addresses
DisabledIGMPv3 IP header validation
NoneStatic router port for IGMP
snooping
Ports and LEDs
AutonegotiationPort link speed
Factory Default Settings and Technical Specifications
76
Nighthawk S8000 Gaming & Streaming Advanced 8-Port Gigabit Ethernet Switch (GS808E)
To Next Page
Loading...
General