NETGEAR AC1200 User Manual

1
Install Your Router
Make sure that your Internet service is active before you install the
router.
 T
o install your router:
1. Prepare your modem.
a. Unp
lug your modem’s
power.
b. If
the modem has a
battery backup, remove 
its batteries.
c. If
your modem was
already connected to
another router, disconnect
the cable between your
modem and that router.
Your modem should be turned off, and cabled only to the wall jack
for
your Internet service.
Internet
DSL or cable
Modem

NETGEAR AC1200 Specifications

General

2.4 GHz	Yes
Modulation	-
Frequency band	2.4 - 5 GHz
Number of users	- user(s)
Channels quantity	- channels
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Maximum data transfer rate	900 Mbit/s
Internal	No
Minimum system requirements	Intel Pentium class PC Available USB 1.1, USB 2.0, or USB 3.0 port Microsoft Windows 7, XP, Vista: (32/64-bit) Supports Windows 8
Cables included	USB
Interface	WLAN
USB version	2.0/3.2 Gen 1 (3.1 Gen 1)
USB connector type	USB Type-A
Connectivity technology	Wireless
Wi-Fi band	Dual-band (2.4 GHz / 5 GHz)
Wi-Fi standards	802.11a, 802.11b, 802.11g
Top Wi-Fi standard	Wi-Fi 4 (802.11n)
WLAN data transfer rates supported	300, 867 Mbit/s
Quantity	1
Windows operating systems supported	Windows 10, Windows 7, Windows 8, Windows 8.1, Windows Vista, Windows XP
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	93 mm
Width	31.4 mm
Height	14.45 mm
Weight	28 g