Wall-Mount the Gateway
82
ADSL2+ Gateway
- Concrete
ļ To wall-mount the gateway:
1. Drill holes in the wall where you want to wall-mount the gateway.
Holes must be 6-9/16 in.
(167 cm) center to center.
2. Install wall anchors in the holes.
3. Use pan head Phillips wood screws, 3.5 x 20 mm (diameter x length, European) or No. 6
type screws, 1" inch long (U.S.).
4. Insert screws into the wall anchors, leaving 1/8 inch (3 mm) of each screw exposed.
To Next Page
Loading...
