Reference Manual for the Model DG834 ADSL Firewall Router
3-12 Connecting the Router to the Internet
Wizard-Detected IP Over ATM Account Setup
If the Setup Wizard determines that your Internet service account uses IP Over ATM Classical IP
assignment (RFC1577), you will be directed to the menu shown in Figure 3-13 below:
Figure 3-13: Setup Wizard menu for IP Over ATM (Classical IP) address
1.
Enter your assigned IP Address and Subnet Mask. This information should have been
provided to you by your ISP. You need the configuration parameters from your ISP you
recorded in “Record Your Internet Connection Information” on page 3-4.
2. Enter the IP address of your ISP’s Primary DNS Server. If a Secondary DNS Server address is
available, enter it also.
DNS servers are required to perform the function of translating an Internet name such as
www.netgear.com to a numeric IP address. For a fixed IP address configuration, you must
obtain DNS server addresses from your ISP and enter them manually here.
3. Click Apply to save the settings.
4. Click the Test button to test your Internet connection. If the NETGEAR Web site does not
appear within one minute, refer to Chapter 7, “Troubleshooting”.
To Next Page
Loading...
