What to do if LAN or WAN Port LEDs are not on on NETGEAR Network Router?
If the LAN or WAN port LEDs are not lit, ensure the following: * The Ethernet cable connections are securely connected to both the router and the hub or workstation. * The connected hub or workstation is powered on. * You are using the correct Ethernet cable.
How to fix NETGEAR Network Router if power LED is not on?
If the power LED is not on, try the following: * Make sure the power cord is properly connected to your router and the power supply adapter is properly connected to a functioning power outlet. * Check that you are using the 12 V DC power adapter supplied by NETGEAR for this product. * If the error persists, you have a hardware problem and should contact technical support.
What to do if Test LED never turns on or stays on NETGEAR DG834 Network Router?
If the Test LED never turns on or stays on, it indicates there is a fault within the router. Cycle the power to see if the router recovers and the LED blinks for the correct amount of time. If all LEDs including the Test LED are still on one minute after power up, cycle the power to see if the router recovers. Clear the router’s configuration to factory defaults. This will set the router’s IP address to 192.168.0.1. If the error persists, you might have a hardware problem and should contact technical support.
What to do if computer does not recognize DNS server addresses of NETGEAR DG834?
If your computer may not recognize any DNS server addresses: * Reboot your computer and verify the DNS address. * You can configure your computer manually with DNS addresses.
General| Device Type | ADSL Modem Router |
|---|---|
| Wireless | No |
| Connectivity Technology | Wired |
| LAN Ports | 4 |
| ADSL Standards | G.dmt, G.lite |
| Firewall | Yes |
| VPN Support | Yes |
| Security Features | NAT, SPI |
| Weight | 310 g |
To Next Page
