NETGEAR DG834

Reference Manual for the ADSL Firewall Router DG834
Connecting the Router to the Internet 3-13
v2.0, September 2005
Wizard-Detected IP Over ATM Account Setup
If the Setup Wizard determines that your Internet service account uses IP over ATM Classical IP
assignment (RFC1577), you will be directed to the page shown in Figure 3-13 below:
1. Enter your assigned IP Address and Subnet Mask. This information should have been
provided to you by your ISP. You need the configuration parameters from your ISP you
recorded in “Record Your Internet Connection Information” on page 3-4.
2. Enter the IP address of your ISP’s Primary DNS Server. If a Secondary DNS Server address is
available, enter it also.
DNS servers are required to perform the function of translating an Internet name such as
http://www.netgear.com to a numeric IP address. For a fixed IP address configuration, you
must obtain DNS server addresses from your ISP and enter them manually here.
3. Click Apply to save the settings.
4. Click the Test button to test your Internet connection. If the NETGEAR Web site does not
appear within one minute, refer to Chapter 8, “Troubleshooting”.
Figure 3-13