Reference Manual for the ADSL Firewall Router DG834
7-30 Virtual Private Networking (Advanced Feature)
v2.0, September 2005
Once the connection is established, you can open the browser of the PC and enter the LAN IP
address of the remote DG834. After a short wait, you should see the login screen of the Router
(unless another PC already has the DG834 management interface open).
• Gateway-to-Gateway Configuration—test the VPN tunnel by pinging the remote network
from a PC attached to the DG834.
a. Open command prompt (i.e., Start -> Run -> cmd).
b. ping 192.168.3.1.
Start Using a VPN Tunnel to Active It
To use a VPN tunnel, use a Web browser to go to a URL whose IP address or range is covered by
the policy for that VPN tunnel.
Verifying the Status of a VPN Tunnel
To use the VPN Status page to determine the status of a VPN tunnel, perform the following steps:
1. Log in to the Router.
2. Open the DG834 management interface and click on VPN Status to get the VPN Status/Log
screen (Figure 7-35).
Figure 7-33
Figure 7-34
Note: The pings may fail the first time. If so, then try the pings a second time.
To Next Page
Loading...
