NETGEAR DGND3700 - Test the LAN Path to Your Wireless Modem Router

Troubleshooting
151
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
Test the LAN Path to Your Wireless Modem Router
You can ping the router from your computer to verify that the LAN path to your router is set up
correctly.
 To ping the router from a PC running Windows 95 or later:
1. F
rom the Windows task bar, click the Start button, and select Run.
2. In the field provided, type pin
g followed by the IP address of the router, as in this example:
ping 192.168.0.1
3. Click OK.
You should see a message like this one:
Pinging <IP address> with 32 bytes of data
If the path is working, you see this message:
Reply from < IP address >: bytes=32 time=NN ms TTL=xxx
If the path is not working, you see this message:
Request timed out
If the path is not functioning correctly, you could have one of the following problems:
• W
rong physical connections
- Make sure t
hat the LAN port LED is on. If the LED is off, follow the instructions in
LAN LED Is Off on p
age 147.
- Check tha
t the corresponding link LEDs are on for your network interface card
and for the hub ports (if any) that are connected to your workstation and router.
• W
rong network configuration
- V
erify that the Ethernet card driver software and TCP/IP software are both
installed and configured on your PC or workstation.
- V
erify that the IP address for your router and your workstation are correct and that
the addresses are on the same subnet.