NETGEAR DGND3700 - Set the Time Zone

Security Settings
59
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
• Type. Select the correct type for this service. If in doubt, select TCP/UDP. The options
are TCP, UDP, TCP/UDP.
• Start Port and End
Port. If a port range is required, enter the range here. If a single
port is required, enter the same value in both fields.
3. Click Appl
y to save your changes.
Set the Time Zone
The wireless modem router uses the Network Time Protocol (NTP) to obtain the current time
and date from one of several network time servers on the Internet.
 To set the time zone:
1. Select Cont
ent Filtering > Schedule to display the following screen:
Figure 28. Schedule screen
2. Select your time zone. This setting determines the blocking schedule and time-stamping of
log entries.
3. If your time zone is in
daylight savings time, select the Adjust for Daylight Savings Time
check box to add one hour to standard time.
Note: If your region uses daylight savings time, select Adjust for Daylight
Savings Time on the first day and clear it after the last day.
4. The wireless modem router has a list of NETGEAR NTP servers. If you would prefer to use
a particular NTP server as the primary server, select the Use this NTP Server check box,
and enter its IP address.
5. Click Appl
y to save your settings.