NETGEAR VPN Configuration
166
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
The LAN addresses used in this example are as follows:
Table 26.
Device LAN IP Address LAN Subnet Mask
DGND3700 10.5.6.1 255.255.255.0
FVL328 172.23.6.1 255.255.255.0
a. For the connection name, enter toFVL328.
b. For the remote WAN's IP address, enter fvl328.
dyndns.org.
c. Enter the
following:
• IP Address. 172.2
3.9.1
• Subnet Mask. 255.2
55.255.0
5. Configure the FVL328 as in the gateway-to-gateway procedures for the VPN Wizard (see
Set Up a Ga
teway-to-Gateway VPN Configuration on page 101
), being certain to use
appropriate network addresses for the environment.
a. For the connection name, enter to
DGND3300v2.
b. For the remote WAN's IP address, enter dgnd330
0v2.dyndns.org.
c. Enter the
following:
• IP Address. 10.5.
6.1
• Subnet Mask. 255.2
55.255.0
6. Test the VPN tunnel by pinging the remote network from a PC attached to the N600
Wireless
Dual Band Gigabit ADSL2+ Modem Router DGND3700.
a. Open the command prompt (select S
tart > Run > cmd)
b. Type ping 1
72.23.9.1.
If the pings fail the first time, try the pings a second time.
Configuration Summary (Telecommuter Example)
The configuration in this section follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather the necessary information before you begin configuration.
To Next Page
Loading...
