NETGEAR DGND3700 - VPN Tunnel Control

Virtual Private Networking
105
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
b. Click the VPN Status button to display the Current VPN Tunnels (SAs) screen:
c. Click Connect for the VPN tunnel you want to activate. View the VPN Status/Log
screen to verify that the tunnel is connected.
VPN Tunnel Control
Activate a VPN Tunnel
There are three ways to activate a VPN tunnel:
• Use the VPN Status screen.
•
Ping the remote endpoint.
•
Start using the VPN tunnel.
Note: See Use Auto Policy to Configure VPN Tunnels on page 112 for
information about how to enable the IKE keep-alive capability on an
existing VPN tunnel.
Use the VPN Status Screen to Activate a VPN Tunnel
 To use the VPN Status screen to activate a VPN tunnel:
1. Log in to the wireless modem router.