Virtual Private Networking
106
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
2. On the main menu, select VPN Status. The VPN Status/Log screen displays:
3. Click VPN Status to display the Current VPN Tunnels (SAs) screen:
4. Click Connect for the VPN tunnel that you want to activate.
Activate the VPN Tunnel by Pinging the Remote Endpoint
Note: This section uses 192.168.3.1 for a sample remote endpoint LAN IP
address.
To activate the VPN tunnel by pinging the remote endpoint (for example, 192.168.3.1),
perform the following steps depending on whether your configuration is client-to-gateway or
gateway-to-gateway:
• Client-to-gateway configuration. T
o check the VPN connection, you can initiate a
request from the remote PC to the N600 Wireless Dual Band Gigabit ADSL2+ Modem
Router DGND3700’s network by using the Connect option in the NETGEAR ProSafe
To Next Page
Loading...
