Virtual Private Networking
107
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
menu bar. The NETGEAR ProSafe client reports the results of the attempt to connect.
Since the remote PC has a dynamically assigned WAN IP address, it has to initiate the
request.
To perform a ping test using our example, start from the remote PC:
a. Est
ablish an Internet connection from the PC.
b.
On the Windows taskbar, click the St
art button, and then select Run.
c. Type ping -
t 192.168.3.1, and then click OK.
Running a ping test
to the LAN from the PC
This causes a continuous ping to be sent to the first N600 Wireless Dual Band Gigabit
ADSL2+ Modem Router DGND3700. Within 2 minutes, the ping response should
change from timed out to reply.
Note: You can use Ctrl-C to stop the pinging.
Once the connection is established, you can open a browser on the PC and enter the
LAN IP address of the remote N600 Wireless Dual Band Gigabit ADSL2+ Modem Router
DGND3700. After a short wait, you should see the login screen of the wireless modem
router (unless another PC already has the N600 Wireless Dual Band Gigabit ADSL2+
Modem Router DGND3700 management interface open).
• Gateway-to-
gateway confi
guration. Test the VPN tunnel by pinging the remote network
from a PC attached to Gateway A (the wireless modem router).
a. Open a command prompt (for example, S
tart > Run > cmd).
b. Type pi
ng 192.168.3.1.
To Next Page
Loading...
