NETGEAR VPN Configuration
170
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
Note: In this example, the connection name on the client side of the VPN
tunnel is toGW_A. It does not have to match the VPN_client connection name
used on the gateway side of the VPN tunnel because connection names do not
affect how the VPN tunnel functions.
d. In the Connection Security section
, select Secure.
e. In the ID Type drop-down list, select IP Subnet.
f. In this example, in the Su
bnet field, type 192.168.0.1 as the network address of the
wireless modem router.
g. In the Mask field, enter
255.255.255.0 as the LAN subnet mask of the wireless
modem router.
h. In the Protocol drop-do
wn list, select All to allow all traffic through the VPN tunnel.
i. Select the Connect using
Secure Gateway Tunnel check box.
j. In the ID Type drop-down list, select Domain Name
, and enter fromGW_A.com (in
this example).
k. Select Gatewa
y Hostname and enter ntgr.dyndns.org (in this example).
3. Configure the security policy in the wireless modem router software.
To Next Page
Loading...
