Virtual Private Networking
94
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
The PC has to have the NETGEAR ProSafe VPN Client program installed, which supports
IPSec. Go to the NETGEAR website (http://www.netgear.com) for information about how to
purchase the NETGEAR ProSafe VPN client.
Note: Before installing the NETGEAR ProSafe VPN Client software, be
sure to turn off any virus protection or firewall software you might be
running on your PC. You might need to insert your Windows CD to
complete the installation.
To configure the NETGEAR ProSafe VPN client:
1. Install the NETGEAR ProSafe VPN client on the remote PC, and then reboot.
a. Install the IPSec component. You might have th
e option to install either the VPN
adapter or the IPSec component or both. The VPN adapter is not necessary.
If you do not have a modem or dial-up adapter installed in yo
ur PC, you might see the
warning message stating, “The NETGEAR ProSafe VPN Component requires at least
one dial-up adapter be installed.” You can disregard this message.
b. Reboot th
e remo
te PC.
The ProSafe icon (
) is in the system tray.
c. Double-click the ProSafe icon
to open the Security Policy Editor.
2. Add a new connection.
a. Run the NETGEAR
ProSafe Security Policy Editor program, and, using Table 17 on
page 91, create a VPN connection.
b. From the Edit menu of
the Security Policy Editor, select Add, and then click
Connection.
A New Connection listing appears in the list of policies.
To Next Page
Loading...
