2-2
For example, connect the composite video cables between your
entertainment system and the Digital Entertainer HD.
If you use a digital audio/visual (A/V) receiver, NETGEAR
recommends that you use an S/PDIF coaxial or an optical cable to
connect it.
The quality of the picture display is related to the video format you
use. If your television supports multiple formats, choose the format
that provides the best picture quality. HDMI offers the best picture
quality video. Component video provides the next best quality,
followed by S-Video, Composite Video, and SCART.
2. Connect the Digital Entertainer HD to your network.
• If you are connecting to Ethernet LAN, connect the Digital
Entertainer HD to the LAN with an Ethernet cable.
• If you are connecting to your wireless network, configure the
wireless settings of the Digital Entertainer HD using the Basic
Setup steps described in the following section. Be prepared to
provide the wireless network name (also called SSID) and the
wireless security settings for your network.
3. Connect the power cord, and plug it into an outlet.
The LED on the front of the Digital Entertainer HD lights up to show
that it is powered on.
4. Install the two AA batteries into the remote control that came with the
product.
5. Turn on the television, and set the video source selector on your
television to match the connection from your Digital Entertainer HD.
For example, if you used an HDMI connector, set the television to use
Digital HD or HDMI input.
Optimize the television display as needed.
• If the display is not sharp, or you do not see a picture, aim the
NETGEAR remote control at the Digital Entertainer HD, and
press the TV Mode button.
To Next Page
Loading...
