NETGEAR FVS336Gv3 - Page 258

Customize Firewall Protection
258
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
8. Enter the settings as described in the following table.
Setting Description
Service From the menu, select CU-SEEME:UDP.
Action From the menu, select ALLOW by schedule, otherwise block.
(If you do not want to use a schedule, select ALLOW always.)
Select Schedule From the menu, select a schedule.
For information about how to configure schedules, see Define a Schedule on
page 294.
Send to LAN Server From the menu, select Single address.
In the Start field, enter the LAN IP address of the server that receives the video
traffic.
WAN Destination IP
Address
The setting that determines the destination IP address applicable to incoming traffic.
This is the public IP address that maps to the internal server on the LAN that
receives the video traffic.
From the menu, select the WAN interface that you want to use.
WAN Users From the menu, select Address Range.
In the Start and Finish fields, specify the WAN address range from which the VPN
firewall accepts video traffic.
QoS Profile You can leave the selection from the menu at None.