NETGEAR FVS336Gv3 - Page 259

Customize Firewall Protection
259
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
9. Click the Apply button.
Your settings are saved. The new rule is added to the Inbound Services table on the LAN
WAN Rules screen.
IPv4 LAN WAN Inbound Rule: Set Up One-to-One NAT Mapping
In this example, you configure multi-NAT to support multiple public IP addresses on one
WAN interface. An inbound rule configures the VPN firewall to host an additional public IP
address and associate this address with a web server on the LAN. (Instead of on the LAN,
you could also configure this web server in the DMZ.)
The example uses the following addressing scheme:
• NETGEAR VPN firewall:
- WAN IP address. 10.1.0.118
- LAN IP address subnet. 192.168.1.1 with subnet 255.255.255.0
• Web server computer on the VPN firewall’s LAN:
- LAN IP address. 192.168.1.2
- Access to the web server is through the public IP address. 10.168.50.1
Tip: If you arrange with your ISP to have more than one public IP address
for your use, you can use the additional public IP addresses to map to
servers on your LAN or DMZ. One of these public IP addresses is
used as the primary IP address of the router that provides Internet
access to your LAN computers through NAT. The other addresses are
available to map to your servers.
 To configure the VPN firewall for additional IP addresses:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
Log You can leave the selection from the menu at Never.
Bandwidth Profile You can leave the selection from the menu at NONE.
Setting Description