•
Includes the following mounting hardware:
-
Four rubber footpads for tabletop installation.
-
Wall-mount screw kit for wall installation.
•
Full compatibility with IEEE standards:
- IEEE 802.3 Ethernet.
- IEEE 802.3u 100BASE-T.
- IEEE 802.3ab 1000BASE-T.
- IEEE 802.3z Gigabit Ethernet 1000BASE-SX/LX.
- IEEE 802.1Q VLAN tagging.
-
IEEE 802.3x Full-duplex flow control.
- IEEE 802.3ad Link aggregation (LAG with LACP).
- IEEE 802.1ab LLDP.
-
IEEE 802.1p Class of Service (QoS).
- IEEE 802.1D Spanning Tree Protocol (STP).
- IEEE 802.1s Multiple Spanning Tree Protocol (MSTP).
- IEEE 802.1w Rapid Spanning Tree Protocol (RSTP).
- IEEE 802.1x RADIUS network access control.
-
IEEE 802.3az Energy Efficient Ethernet (EEE).
-
IEEE 802.3af (PoE).
- IEEE 802.3at (PoE+).
•
AutoSensing and autonegotiating capabilities for all ports.
•
Auto Uplink™ technology is supported on all ports.
•
Automatic address learning function to build the packet-forwarding information
table. The table contains up to 8K Media Access Control (MAC) addresses.
•
Store-and-forward transmission to remove bad packets from the network.
•
Active flow control to minimize packet loss and frame drops.
•
Half-duplex backpressure control.
•
Per-port status LEDs and system status LEDs:
-
Power/Cloud LED that provides status information on both the system power
and the cloud connection.
Hardware Installation Guide8Introduction
Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power
To Next Page
Loading...
