•
Use only the supplied DC power adapter. If you were not provided with a DC power
adapter, contact your reseller.
•
To help prevent electric shock, plug the system and peripheral power cables into
properly grounded electrical outlets.
•
The peripheral power cables are equipped with three-prong plugs to help ensure
proper grounding. Do not use adapter plugs or remove the grounding prong from
a cable. If you must use an extension cable, use a three-wire cable with properly
grounded plugs.
•
Observe extension cable and power strip ratings. Make sure that the total ampere
rating of all products plugged into the extension cable or power strip does not
exceed 80 percent of the ampere ratings limit for the extension cable or power strip.
•
To help protect your system from sudden, transient increases and decreases in
electrical power, use a surge suppressor, line conditioner, or uninterruptible power
supply (UPS).
•
Position system cables and power cables carefully. Route cables so that they cannot
be stepped on or tripped over. Be sure that nothing rests on any cables.
•
Do not modify power cables or plugs. Consult a licensed electrician or your power
company for site modifications.
•
Always follow your local and national wiring rules.
Hardware Installation Guide12Introduction
Insight Managed 28-Port and 52-Port Gigabit Ethernet (PoE+) Smart Cloud Switch
To Next Page
Loading...
Need help?
General
