SFP and SFP+ Ports for Fiber Connectivity
To enable fiber connections on the switch, SFP and SFP+ fiber ports accommodate
standard small form-factor pluggable (SFP) gigabit interface converters (GBICs, also
referred to as transceiver modules). GBICs are sold separately from the switch.
The switch supports the NETGEAR SFP and SFP+ transceiver modules that are listed in
the following table.
Table 5. Supported SFP and SFP+ transceiver modules
DescriptionModelSpeed and Medium
SFP transceiver 1000BASE-SXAGM731F1G Ethernet short-reach fiber
SFP transceiver 1000BASE-LXAGM732F1G Ethernet long-reach fiber
SFP transceiver 1000BASE-TAGM7341G Ethernet copper
SFP+ transceiver 10GBASE-SR multimodeAXM76110GBASE short-reach fiber
SFP+ transceiver 10GBASE-LR single
mode
AXM76210GBASE long-range fiber
SFP+ transceiver 10GBASE-LRM
multimode
AXM76310GBASE long-range fiber
SFP+ transceiver 10GBASE-LR Lite single
mode
AXM76410GBASE long-range fiber lite
SFP+ Transceiver 10GBASE-TAXM76510GBASE copper
SFP+ DAC cable, 3 feet (1 meter)AXC76110G Ethernet copper
SFP+ DAC cable, 9 feet (3 meters)AXC76310G Ethernet copper
For more information about NETGEAR SFP and SFP+ transceiver modules, visit
netgear.com/business/products/switches/modules-accessories.
Note: If you use a third-party passive direct-attach cable (DAC), the length of the cable
must not exceed 16.4 feet (5 meters).
USB Port
The switch provides one USB 2.0 port that lets you upload firmware, upload or download
(back up) the configuration settings file, and download a memory dump (for debugging
purposes) using a USB storage device.
Hardware Installation Guide21Hardware Overview
Insight Managed 28-Port and 52-Port Gigabit Ethernet (PoE+) Smart Cloud Switch
To Next Page
Loading...
Need help?
General
