Contact your NETGEAR reseller to purchase these modules. If you do not want to
install an SFP module, skip this procedure.
Note
To install an SFP transceiver module:
1. Insert the transceiver into the SFP port.
2. Press firmly on the flange of the module to seat it securely into the connector.
Step 6: Check the Installation
Before you apply power to the switch, perform the steps that are described in this section.
To check the installation:
1. Inspect the equipment thoroughly.
2. Verify that all cables are installed correctly.
3. Check cable routing to make sure that cables are not damaged or creating a safety hazard
4. Make sure that all equipment is mounted properly and securely.
Installation
18
48-Port Gigabit Ethernet Smart Managed Plus Switch
To Next Page
Loading...
