If the QoS mode on the switch is Port-Based, we recommend that you first save your
current QoS settings as a custom preset mode before you change the QoS mode to
the 802.1P/DSCP QoS mode. For more information, see Save Your Quality of Service
Settings as a Custom Preset Mode on page 28.
Note
To use 802.1P/DSCP QoS mode and set the rate limits for ports:
1. Open a web browser from a computer that is connected to the same network as the switch or to the
switch directly through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
The login page displays.
3. Enter the switch password.
The default password is password. The password is case-sensitive.
The HOME page displays.
4. From the menu at the top of the page, select SWITCHING.
The QOS page displays.
5. If the selection from the QoS Mode menu is Port-Based, do the following to change the selection to
802.1P/DSCP:
a. From the QoS Mode menu, select 802.1P/DSCP.
A pop-up warning window opens.
b. Click the CONTINUE button.
The pop-up window closes.
For information about broadcast filtering, see Manage Broadcast Filtering and Set
Port Storm Control Rate Limits on page 34.
Note
6. To set rate limits, do the following:
a. Click the RATE LIMITS tab.
b. Click the edit icon.
The rate limit settings become available.
c. For each port for which you want to set rate limits, select the rate in Mbit/s from the individual Ingress
and Egress menus for the port.
The default selection is No Limit.
d. Click the APPLY button.
Your settings are saved.
Optimize the Switch Performance
33
Nighthawk Pro Gaming SX10 Switch Model GS810EMX
To Next Page
Loading...
