Advanced Settings
98
N300 Wireless Gigabit Router with USB JNR3210
2. Select the Port Triggering radio button to display the port triggering information.
3. Clear the Disable Port Triggering check box if it is selected.
Note: If the Disable Port Triggering check box is selected after you configure
port triggering, port triggering is disabled. However, any port triggering
configuration information you added to the router is retained even though it is
not used.
4. In the Port Triggering Timeout field, enter a value up to 9999 minutes.
5. This value controls the inactivity timer for the designated inbound ports. The inbound ports
close when the inactivity time expires. This is required because the router cannot be sure
when the application has terminated.
To Next Page
Loading...
Need help?
General
