Factory default settings
You can return the switch to its factory settings. For more information, see Return
the
switch to its factory default settings on page 72.
The switch resets and returns to the factory settings shown in the following table.
Table 5. Factory default settings
SettingFeature
passwordSwitch password
192.168.0.239 (if the switch is not connected to a network with a DHCP server)IP address
255.255.255.0Subnet mask
EnabledDHCP mode
EnabledIGMP snooping
None configuredLAGs
Disabled. If enabled, by default, all ports are members of VLAN 1.VLANs
Enabled802.1p/DSCP-based QoS
DisabledPort-based QoS
DisabledRate limiting
DisabledBroadcast filtering
EnabledLoop prevention
AutonegotiationPort speed
DisabledFlow control
DisabledPort mirroring
User Manual109Factory Default Settings and
Technical Specifications
8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch
To Next Page
Loading...
