NETGEAR MS108EUP - Configure the System Time Manually; Configure the SNTP Client Mode

Configure the system time manually
To set the system time manually:
1.
Open a web browser from a computer that is connected to the same network as the
switch, or connected directly to the switch through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
A login window opens.
3. Enter the device management password.
The password is the one that you specified the first time that you logged in. The
password is case-sensitive.
The HOME page displays.
4. In the SYSTEM TIME section, click the down arrow to expand the menu.
The system time options display.
5. Select Local on the toggle.
The button displays on the left side of the toggle, and the toggle bar turns gray.
6.
Click in the Date field and select the date from the pop-up menu.
The date field displays the date that you set.
7.
Click in the Time field and select the time from the pop-up menu.
The time field displays the time that you set.
8. Click the APPLY button.
Your settings are saved.
The current system date and time display next to the menu icon.
Configure the SNTP client mode
You can configure the SNTP client mode as unicast or broadcast.
Note: Automated time syncing depends on the switch knowing how to contact your
SNTP servers, and then activating automated time syncing. For more information, see
Configure
an SNTP server on page 87 and Enable system time to synchronize with an
SNTP server on page 88.
To enable SNTP client mode and configure it for unicast or broadcast:
1.
Open a web browser from a computer that is connected to the same network as the
switch, or connected directly to the switch through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
User Manual85Maintain and Monitor the Switch
8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch