7.
Write down the complete fixed IP address.
You can bookmark it later.
8. Click the APPLY button.
Your settings are saved. Your switch web session is disconnected when you change
the IP address.
9.
If the login page does not display, enter the new IP address of the switch in the
address field of your web browser.
The login page displays.
10. For easy access to the device UI, bookmark the page on your computer.
Assign a fixed IP address by connecting directly to the switch
off-network If you cannot connect to the switch over a network connection, you can
use an Ethernet cable to connect your computer directly to the switch, and then you
can set the IP address of the switch.
To disable the switch's DHCP client and change the IP address of the switch to a
fixed IP address through a direct connection:
1.
Connect an Ethernet cable from your computer to an Ethernet port on the switch.
2.
Change the IP address of your computer to be in the same subnet as the default IP
address of the switch.
The default IP address of the switch is 192.168.0.239 and, to connect to it, your
computer's IP address must be on the same subnet (192.168.0.x).
The method to change your computer's IP address depends on the operating system
of your computer.
3.
Open a web browser from a computer that is connected to the same network as the
switch, or connected directly to the switch through an Ethernet cable.
4.
Enter 192.168.0.239 as the IP address of the switch.
The login page displays.
5. Enter the device management password.
The password is the one that you specified the first time that you logged in. The
password is case-sensitive.
The HOME page displays.
The right pane (or, depending on the size of your browser window, the middle pane)
shows the IP address that is assigned to the switch.
6. Select IP Address (DHCP On).
User Manual19Install and Access the Switch in
Your Network
8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch
To Next Page
Loading...
