Set a fixed IPv6 Internet connection
To set a fixed IPv6 Internet connection:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
A login window displays.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > IPv6.
The IPv6 page displays.
5. From the Internet Connection Type menu, select Fixed.
The page adjusts.
6. Configure the fixed IPv6 addresses for the WAN connection:
•
IPv6 Address/Prefix Length: The IPv6 address and prefix length of the router
WAN interface.
•
Default IPv6 Gateway: The IPv6 address of the default IPv6 gateway for the
router’s WAN interface.
•
Primary DNS Server: The primary DNS server that resolves IPv6 domain name
records for the router.
•
Secondary DNS Server: The secondary DNS server that resolves IPv6 domain
name records for the router.
NOTE: If you do not specify the DNS servers, the router uses the DNS servers
that are configured for the IPv4 Internet connection on the Internet Setup
page. (See Manually set up the Internet connection on page 30.)
7. Select an IP Address Assignment radio button:
•
Use DHCP Server: Use this method if devices on the LAN cannot receive an IPv6
address through auto configuration but must receive an IPv6 address through a
DHCP server.
•
Auto Config: This is the default setting.
This setting specifies how the router assigns IPv6 addresses to the devices on your
home network (the LAN).
8. (Optional) Select the Enable RIPng check box.
User Manual42Specify Your Internet Settings
Nighthawk WiFi 7 Tri-Band Router Model RS300, Model RS280
To Next Page
Loading...
