Use the WPS Wizard with the push button
To use the push button method to connect a WiFi device to your WiFi network, the
device must have either a physical button or a software button.
To use the WPS Wizard with the push button:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
A login window displays.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > WPS Wizard.
A note explaining WPS displays.
5. Click the Next button.
The Add WPS Client page displays.
By default, the Push Button (recommended) radio button is selected.
6. Click the green WPS software button on the page.
7. Within two minutes, go to the WPS-enabled device and use its WPS software to
connect to the WiFi network.
The WPS process automatically sets up the WPS-enabled device with the network
password when it connects. The router web interface displays a confirmation message.
Use the WPS Wizard with a PIN
To use a PIN to connect a WiFi device to your WiFi network, you must know the PIN of
the device.
To use the WPS Wizard with a PIN:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
A login window displays.
3. Enter the router admin user name and password.
User Manual81Manage WiFi Settings
Nighthawk WiFi 7 Tri-Band Router Model RS300, Model RS280
To Next Page
Loading...
