NETGEAR Nighthawk X4S

• Set Up an IPv6 6rd Internet Connection on page 33
• Set Up an IPv6 6to4 Tunnel Internet Connection on page 35
• Set Up an IPv6 Pass Through Internet Connection on page 36
• Set Up an IPv6 Fixed Internet Connection on page 37
• Set Up an IPv6 DHCP Internet Connection on page 38
• Set Up an IPv6 PPPoE Internet Connection on page 40
6. Click the Apply button.
Your settings are saved.
Requirements for Entering IPv6 Addresses
IPv6 addresses are denoted by eight groups of hexadecimal quartets that are separated by colons.You can reduce
any four-digit group of zeros within an IPv6 address to a single zero or omit it.The following errors invalidate an
IPv6 address:
• More than eight groups of hexadecimal quartets
• More than four hexadecimal characters in a quartet
• More than two colons in a row
Use Auto Config for an IPv6 Internet Connection
To set up an IPv6 Internet connection through autoconfiguration:
1. Launch a web browser from a computer or WiFi device that is connected to the network.
2. Enter http://www.routerlogin.net.
A login window opens.
3. Enter the router user name and password.
The user name is admin.The default password is password.The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > IPv6.
The IPv6 page displays.
5. From the Internet Connection Type menu, select Auto Config.
Specify Your Internet Settings
30
Nighthawk X4S AC2600 Smart WiFi Router