NETGEAR Nighthawk X4S

5
Network Settings
The router comes ready for WiFi, Ethernet, and USB connections.You can customize the router’s network settings.We
recommend that you install the router and connect it to the Internet before you change its network settings.
This chapter includes the following sections:
• View or Change WAN Settings on page 58
• Set Up a Default DMZ Server on page 59
• Change the Router’s Device Name on page 60
• Change the LAN TCP/IP Settings on page 60
• Specify the IP Addresses That the Router Assigns on page 62
• Disable the DHCP Server Feature in the Router on page 64
• Manage Reserved LAN IP Addresses on page 64
• Use the WPS Wizard for WiFi Connections on page 66
• Specify Basic WiFi Settings on page 67
• Change the WiFi Password or Security Level on page 71
• Set Up a WiFi Schedule on page 77
• Enable or Disable WiFi 160 MHz on page 72
• Enable a WiFi Video Network on page 72
• Set Up a Guest WiFi Network on page 73
• Enable a WiFi Video Network on page 72
• Control the WiFi Radios on page 76
• Set Up a WiFi Schedule on page 77
• Specify WPS Settings on page 78
• Use the Router as a WiFi Access Point on page 79
• Use the Router in Bridge Mode on page 80
• Set Up a Bridge for a Port Group or VLAN Tag Group on page 82
57