Need help?Do you have a question about the NETGEAR ProSAFE JGS524PE and is the answer not in the manual?
General| Model | JGS524PE |
|---|---|
| Category | Switch |
| PoE Budget | 190W |
| Switching Capacity | 48 Gbps |
| VLAN Support | Yes |
| QoS | Yes |
| Form Factor | Rack-mountable |
| Forwarding Rate | 35.7 Mpps |
| MAC Address Table Size | 8K |
| PoE Standard | 802.3af |
| Humidity | 10% to 90% non-condensing |
| Power Supply | Internal |
| Ports | 24 |
| PoE Ports | 12 |
| Management | Web-based |
| Switch Type | Smart Managed |
| Operating Temperature | 0 to 50°C |
| Storage Temperature | -20 to 70°C |
| Input Voltage | 100-240V AC |
| Jumbo Frame Support | 9, 216 bytes |
Lists the switch models supported by the manual.
Explains basic setup and configuration options for the switch.
Details how to access the switch's management interface via a web browser.
Introduces the utility for managing switches.
Instructions for changing the switch's default password for security.
Explains how to set static IP addresses or use DHCP for the switch.
Prioritizes traffic based on packet header QoS information.
Advanced 802.1Q VLAN setup with tagged/untagged ports and PVIDs.
Instructions for updating the switch firmware.
Resets the switch to its original factory default settings.
To Next Page
