Configure System Information
63
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
7. From the Version menu, select the trap version to be used by the SNMP trap receiver:
• SNMPv1. The switch uses SNMPv1 to send traps to the receiver.
• SNMPv2. The switch uses SNMPv2 to send traps to the receiver.
8. In the Community String field, specify the name of the SNMP community that includes
the SNMP management host and the SNMP agent on the device.
This name can be up to 16 characters and is case-sensitive.
9. Click the Add button.
The receiver configuration is added.
Modify Information About an Existing SNMP Recipient
 To modify information about an existing SNMP recipient:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select System > SNMP > SNMPv1/v2 > Trap Configuration.
The Trap Configuration page displays.
6. Select the check box for the recipient.
7. Update the fields as needed.
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Delete an SNMP Recipient
 To delete an SNMP trap recipient:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
To Next Page
Loading...
Need help?
General