NETGEAR PS121 User Manual

User Manual for the NETGEAR PS121 Mini Print Server
2-6 Introduction
Diagnostic/Reset Push Button
This button has 2 functions:
• Restore the factory default settings
• Print a test page containing all current settings
Figure 2-5: Print Server recessed diagnostic/reset button
The button is recessed. Use a pin or paper clip to press it.
How to Restore the Factory Default Settings
1. Unplug the Print Server.
2. Press and hold the diagnostic button. While pressing the button, plug in the Print Server and
continue pressing the button for 10 seconds.
How to Generate a Diagnostic Printout
Note: PostScript printers are unable to print this page. If you have a PostScript printer, the test
page will not be printed.
1. Ensure that both the Print Server and the attached printer are on.
2. Press the diagnostic button, and hold it in for 2 seconds.
3. The test page, containing the current settings, will print.
Recessed Diagnostic/Reset Button

NETGEAR PS121 Specifications

General

Brand	NETGEAR
Model	PS121
Category	Print Server
Language	English