NETGEAR PS121 User Manual

User Manual for the NETGEAR PS121 Mini Print Server
3-4 Setup
Now, Install and Configure the PS121 Software
Note: Any print manager software from a printer manufacturer such as Epson or HP should be
uninstalled before installing the PS121 software. See the NETGEAR, Inc. Web site at
http://www.netgear.com/support/main.asp for information on Print Manager software
compatibility.
Follow the steps below to install the software for PS121 and set it up on your network.
Install the PS121 software.
a. Power on your computer, let the
operating system boot up completely,
and log in as needed.
b. Insert the Resource CD for the PS121
into your CD-ROM drive. The CD main
page shown at the right will load.
c. Click Install Software.
d. Click Next and follow the software
installation utility prompts to complete
the software installation.
e. Click Finish to run the Print Server
Setup Wizard.
NETGEAR PS121 Mini Print Server Resource CD
NETGEAR Print Server Installation

NETGEAR PS121 Specifications

General

Brand	NETGEAR
Model	PS121
Category	Print Server
Language	English