NETGEAR PTV3000

Set Up the Push2TV Adapter
6
Push2TV Wireless Display Adapter PTV3000
Requirements
To wirelessly display content through the Push2TV adapter, you need the following:
• TV with an HDMI connector
• Push2TV adapter
• HDMI cable
• A smartphone, tablet, or laptop that is enabled for Intel WiDi or Miracast wireless display
Push2TV Adapter Front, Rear, and Side Views
The following figure shows the front panel, rear panel, and right side panel of the Push2TV
adapter.
Single-color white LED
Reset button
HDMI port
USB power port
Front panel
Rear panel
Right side panel
WPS button
Figure 1. Push2TV adapter front panel, rear panel, and right side panel