Cable Your Router
Power on your router and connect it to a modem.
Figure 5. Cable your router
To cable your router:
1.
Unplug your modem’s power, leaving the modem connected to the wall jack for
your Internet service.
If your modem uses a battery backup, remove the battery.
2. Plug in and turn on your modem.
If your modem uses a battery backup, put the battery back in.
3.
Connect your modem to the Internet port of your router with the Ethernet cable that
came with your router.
4. Connect the power adapter to your router and plug the power adapter into an outlet.
5.
Press the Power On/Off button on the rear panel of the router.
Wall-Mount Your Router
Wall-mounting holes on the bottom let you wall-mount your router.
User Manual15Hardware Setup
Nighthawk AC1750 Smart WiFi Router
To Next Page
Loading...
