To cable your router:
1.
Unplug your modem, remove and reinsert the backup battery if it uses one, and
then plug the modem back in.
2. Use the Ethernet cable to connect the modem to the yellow Internet port on the
router.
Note: If your Internet connection does not require a modem, connect your main
Ethernet cable to the yellow Internet port on the router.
3. Connect the power adapter to your router and plug the power adapter into an outlet.
4.
Press the Power On/Off button on the rear panel of the router.
The router’s Power LED lights solid white when the router is ready.
Turn the LEDs On or Off Using the LED
On/Off Switch
You can turn off the router LEDs using the LED On/Off switch on the rear panel of the
router. The Power LED stays lit even if the LED On/Off switch is in the Off position.
Note: You can also log in to the router to disable or enable LED blinking or turn off the
LEDs (see Disable LED Blinking or Turn Off LEDs on page 113).
User Manual17Hardware Setup
Nighthawk AX12 12-Steam AX6000 WiFi Router
To Next Page
Loading...
Need help?
General
