f.
Click the Apply button.
Your settings are saved.
View or Change the Router Ethernet Port Aggregation
Mode
To view or change your router's Ethernet port aggregation mode:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter http://www.routerlogin.net.
A login window opens.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED > Advanced Setup > Ethernet Port Aggregation.
The Ethernet Port Aggregation page displays.
5. Select an Ethernet port aggregation mode:
• Disable. This mode is selected by default. This mode disables Ethernet port
aggregation on your router. Ethernet ports 1 and 2 can be used as independent
Ethernet ports.
• Enable (LACP-IEEE 803.3ad). The router communicates with the device connected
to Ethernet ports 1 and 2 on your router, and checks to see if Ethernet port
aggregation is supported on the device. If Ethernet port aggregation is supported,
the router automatically trunks Ethernet ports 1 and 2. If not, Ethernet ports 1 and
2 work as independent Ethernet ports. We recommend that you select this mode
unless your NAS or switch can support static LAG only.
• Static. If your device supports a static link aggregation group (LAG) only, select
this mode. Otherwise, we recommend that you to select the Enable (LACP-IEE
803.3ad) radio button instead.
Note: You must enable static mode before you connect your device to Ethernet
ports 1 and 2 on the router.
User Manual97Manage Network Settings
Nighthawk AX12 12-Steam AX6000 WiFi Router
To Next Page
Loading...
Need help?
General
