4. Select ADVANCED > Advanced Setup > VLAN / Bridge Settings.
The VLAN / Bridge Settings page displays.
5. Select the Enable VLAN / Bridge Group check box.
The page expands.
6. Select the By VLAN tag group radio button.
The section expands.
7. Click the Add button.
The Add VLAN Rule page displays.
The table includes default VLAN 10 that has all Ethernet ports and WiFi networks as
members. This VLAN is enabled by default.
8. Specify the settings as described in the following table.
DescriptionField
Enter a name for the VLAN tag group.
The name can be up to 10 characters.
Name
Enter a value from 1 to 4094.VLAN ID
Enter a value from 0 to 7.Priority
9. Select the check box for a wired Ethernet port.
If your device is connected to an Ethernet port on the router, select the Ethernet port
check box that corresponds to the Ethernet port on the router to which the device
is connected.
You must select at least one Ethernet port. You can select more than one port.
10. Click the Add button.
The VLAN tag group is added.
11. Click the Apply button.
Your settings are saved.
Improve network connections with
Universal Plug and Play
Universal Plug and Play (UPnP) helps devices, such as Internet appliances and computers,
access the network and connect to other devices as needed. UPnP devices can
automatically discover the services from other registered UPnP devices on the network.
User Manual75Specify Network Settings
Orbi Tri-band Mesh WiFi 6 System
To Next Page
Loading...
