NETGEAR RBR660 - Always Use HTTPS to Access the Router

To reset your admin password:
1. Launch a web browser from a computer or mobile device that is connected to your
Orbi network.
2. Enter orbilogin.com.
A login window displays.
3. Click the Cancel button.
If password reset is enabled, you are prompted to enter the router's serial number.
4. Enter the router’s serial number in the field.
You can find the router's serial number on the router label.
5. Click the CONTINUE button.
6. Enter your answers to the security questions.
You defined these answers when you set up the password reset feature.
7. Click the CONTINUE button.
You are requested to set a new admin password and set new security questions.
8. Enter your new admin password, set new security questions and answers, and click
the NEXT button.
Your settings are saved.
9. Click the LOGIN AGAIN button.
A login window displays.
10. With your new admin password, log in to the router.
Always use HTTPS to access the
router
You can configure the router to require HTTPS connections between your web browser
and the router web interface, for example, “https://www.orbilogin.com”. When you
enable the HTTPS requirement, connection requests to the router web interface that
specify HTTP are automatically converted to HTTPS.
NOTE: After you enable the HTTPS requirement, when you visit
https://www.orbilogin.com, your browser might display a security warning
because of the self-signed certificate on the router. This is expected behavior.
You can proceed, or add an exception for the security warning. For more
information, visit
kb.netgear.com/000062980/what-to-do-incase-of-security-message.
User Manual83Mantain and Monitor Your
Network
Orbi Tri-band Mesh WiFi 6 System