NETGEAR Trek PR2000 Instalaltion Guide

12
Internet Connection at Home Setup
Connect to the Internet with an Ethernet cable.
NETGEAR
Power
Internet
WiFi
USB
Wired
Power Off
Wireles
DSL or
cable modem
(Optional) Connect a USB device to the USB port
 To connect to the Internet with an Ethernet cable:
1. Connect an Ethernet cable between the Internet port of the Trek
and the Ethernet port of your DSL or cable modem.
2. Connect the Trek to a power source.
For more information, see Power Inputs on page 5.
3. Turn on power to the Trek by moving the Internet Mode switch
from the Power Off position to the Wired position.

NETGEAR Trek PR2000 Specifications

General

Brand	NETGEAR
Model	Trek PR2000
Category	Network Router
Language	English