NETGEAR WAX610

•
LAN/PoE+ port. You can use the LAN/PoE+ Gigabit Ethernet RJ-45 LAN port to
connect the access point to a PoE+ switch, or if you use an optional power adapter,
to a non-PoE switch.
The LAN/PoE+ port supports Ethernet speeds up to 2.5 Gbps when connected to
2.5 Gbps equipment. Your Internet connection, modem, and switch all need to
support a speed of 2.5 Gbps. If one of these components supports only 1 Gbps
(which is a common speed), the access point LAN/PoE+ connection functions at 1
Gbps.
For more information about the LAN/PoE+ port connection, see Set up and connect
the access point to your network on page 20.
•
DC power connector. If you do not use a PoE+ switch to provide power to the access
point, connect an optional power adapter to the DC power connector.
Note: The back panel provides a Kensington lock slot for an optional security cable.
Product label
The product label of the access point shows the QR code, serial number, MAC address,
default WiFi network name (SSID), and network key (password) of the access point.
Figure 3. Product label
User Manual15Hardware Overview
Insight Managed WiFi 6 AX1800 Dual Band Access Point WAX610 User Manual